A dated and worn door bell doesn’t give a great impression to your own guests. Replacing the exterior button or that outdated “dingdong” chime doesn’t need a certified electrician; itâs a task that Do-It-Yourself homeowners can tackle confidently. Chime containers and new door bell buttons come in various sounds and fashions and will be installed using the existing wiring. With the hour of of energy, the door bell will soon be prepared to announce your visitors using a chime that’s music to your own ears.
Replacing the Door-Bell Button
Locate the primary box and switch the breaker connected with all the doorbell off. Examine the door-bell on the exterior of your home. Remove the screws holding the door-bell to your own house. Should you not see any screws, use a flathead screwdriver to pop the cover off, then remove the screws.
Pull the door-bell device from the house. Hold the probes of a meter against each final screw in the rear of the the system to make sure that the power was turned off.
Each final screw to produce the wires. It’s not required to remember which wire goes to which final since they’re inter-changeable. Tape the wires for your house.
Loosen the terminal screws in the rear of the door-bell unit that is new. Use needle-nose pliers. Tighten the screws. Position and support the the door-bell flat against your residence. Attach the the system together with the screws that are offered.
Replacing the Chime Box
Locate the primary box and flip the breaker change connected to the place together with the doorbell. Remove the protect to the unit. With regards to the type, there could be screws keeping the protect in spot or it could simply snap-on over the foundation that is chime.
Hold the probes of a meter from the terminal screws to make sure that the power continues to be turned. Tape each wire before disconnecting and compose on the tape which wire connects to which final.
Loosen the screws and detach the wires in the terminals. Unscrew the screws which can be holding the foundation to the wall. Pull the the system far from the wall. Tape the wires to the wall from sliding back to the wall to avoid them.
Pick out the cover away from the chime device that is new. Pull the wires throughout the hole of the base that is chime. Hold the the system from the wall to view in the event the outdated wall holes are aligned with all by the holes of the device. Carry on to Stage 5 when they do. Mark the wall to reveal the place for the screw-holes. Set the device that was chime a side and drill little pilot holes to the wall at every reference mark.
Secure the box to the wall using the screws that are offered. Loosen each final screw. Bend and wrap the wire around each final utilizing needle-nose pliers. Tighten the screws. Attach the box protect to the base. Flip the breaker on in the principal box.